Back to Face Lift Floors
Find answers at Wood Flooring Guy.com

Q: One visitor asked, "I recently bought an apt. which has shiny wood floors throughout. I removed some cabinets from the kitchen area and underneath was unfinished wood. I sanded down the area, but am unsure how to proceed as I don't know what was done to the floor previously. What should I use now to finish the floor as close to the original as possible?"

A: If the floors are quite shiny, then you probably have a gloss polyurethane on them. I would suggest 3 applications of Circa 1850 Bowling Alley polyurethane. You can purchase it in quarts at Rona/Home Depot stores. It is an excellent finish. Nice to apply. Dries fast for recoat and stands up to traffic. Lightly sand with fine sandpaper between coats. Make sure to clean up all the dust before brushing on another coat.


Related questions about wood stairs and more:
Other
Uncategorized
>Does Face Lift Floors sell wood?
>Finding it hard to match an existing floor?
>How do I prepare wood floors for folk art style painting?
>Should I frame my fireplace? How?
>How do I install railing posts on hardwood?
Tools
>What type of tool should be used to install tongue in groove flooring?
>Do I just router the bullnose along the 'grain end' of the stair tread?
>I am told by the builder that stair treads have to be glued in. Can I simply put oak slabs over the existing tread? Also, do I have to cut off the outer lip if I go with a thin stair nosing?
>Pneumatic hardwood flooring Nailer or Stapler?
Stairs
>Should I install veneer on treads?
>What should we do with our plywood staircase?
>Do I/how do I remove old stair treads?
>How do I remove adhesive from my risers?
>How do I install hardwood on my stairs?
>Why doesn't anyone want to sand my risers?
>My stairs are creaking a lot and i want to fix this. I have taken up the carpet but can't find any nail heads, I do not know where the joists are, and I can't access the stairs from below. What should I do?
>What is the best type of sander to use on pine treads?
>What is the best way to refinish stair treads?
>Should I use veneer on stair treads?
>What is the best thing to put on interior oak stair treads?
>What kind of paint should I use on the railing?
>Can we stain and polyurethane the stairs before installation?
>Is it a good idea to put hardwood on your stairs?
>Should I glue solid oak treads onto existing fir treads?
>I would like to place a laminate hardwood over my stairs. I do not want to have to remove the stairs and rebuild. How do I do this?
>When placing hardwood on stair treads, do they have to be 1" thick or thicker? And do you use one plank of hardwood or could you use strips of hardwood for stair treads?
>Do I have to remove my banister on my stairs to install the hardwood or can it be left in place?
>Who do I turn to for treads and railing to match my floors?